Trophy ridge quiver how to#

Hand tighten it a few turns but do not tighten completely yet. Locate the cap head screw (H4) and insert it into the bracket (P4). Slide the bottom gripper onto the 2” rods (P3) and fasten with two 10-24 screws and metal washers using the 1/8” Allen Key. Insert two 10-24 screws (H1) from the kit and tighten with the 1/8” Allen Key until secure. Locate the two 2-inch rods (P3) or 4-inch rods (P2) and the bracket (P4) in the conversion kit.

Trophy ridge quiver how to#

The following steps describe how to assemble the bottom section for the two piece quiver. NOTA: Set the hood assembly aside and continue to the next page to complete the bottom section. Slide the gripper with the plastic cups (P8) onto the two rods and fasten with two 10-24 screws and metal washers using the 1/8” Allen Key. Locate and insert the two plastic cups (P8) into the gripper as shown in Detail D. NOTA: These rubber grommets will be replaced by the two plastic cups (P8) from the conversion kit in the next step. Locate the top gripper from the 1-piece quiver and take out the attached rubber grommets by squeezing them on one end and then pushing them down through the hole and out. See Detail B.ĭeslice el clamping bracket onto the rods, but do not tighten yet. Place the cap on the hood, then insert two 8/32” screws and tighten with a 3/32” Allen Key until secure. Tighten with a 1/8” Allen Key until secure. Slide two 6-inch rods (P1) or 4-inch rods (P2) from the conversion kit into the quiver hood and insert two 10-24 screws. Use the parts and hardware from the 1-piece quiver for steps 1-3 but switch out the rods. The following steps describe how to assemble the hood section for the two piece quiver. See Detail E.Īt this point, your 1-piece quiver should be disassembled, set those items aside and take out the conversion kit parts, and sort.

If you have the optional top gripper attached, remove it at this time as well by sliding the rods out of the rubber grommets.